3.0 Sled Pull Registration

3.0 Will strictly follow the 3.0 PPL rules:

1, Turbocharger Rules: Maximum 3.0-inch (76.2mm) inducer bore on the compressor housing. The compressor wheel must protrude at least 1/8 inch into the 3.0-inch bore. Map Width Enhancement (MWE) groove is permitted but must be within the 3.0-inch neck area.

2, Safety Requirements: A 3/8-inch billet steel cross must be installed in the inlet of the turbo within 8 inches of the compressor wheel. Turbo pressure pipe must be either 0.120-inch thick steel or covered with a 5-layer Kevlar blanket.

3, Hitch & Suspension: Hitch height is 26 inches with a 3.75-inch or larger hole. Rear suspension must be locked solid.